Installation instruction Aqua 2000 

 
 

Aqua 2000 dissolving process 

Aqua dissolves the lime that passes through the pipe, which then loses its capability to create deposits on the pipe walls. This is an on-going automated 24/7 protection process. The water surface will become softer after the treatment, it is hence important to reduce the dose of detergents by approximately 25-30 % or to use tablet dosage. 

Any existing deposits present in the pipe and the heating elements in appliances will be also removed over the course of time. The strains in shower and washbasin taps should therefore be cleaned 2-3 times during the first year. The Decalcifier is VDE and CE certified and approved in accordance with EN 60950-1, protection class IP 33. The warranty period is four years. The Decalcifier will continuously run a self-test twice daily to check the function of the unit. If an error occurs the LED’s will flash. 

In normal operation the diodes are illuminated from the bottom and upwards. In case of malfunction, contact your Aqua 2000 supplier. 

Where to install

Aqua 2000 dissolver should be mounted where the water comes into the house on a main straight pipebefore branching off, but after the pump, filter and pressure tanks if any. It can be mounted on pipes of copper, stainless steel, polyethylene, PEM or galvanized material. Any painting or insulation must be removed from the pipes. The unit cannot be used on metal reinforced flexible rubber pipes. If that is the case, remove approx. 15 cm of the pipe and replace it with any of above mentioned one layer pipe on the place of Aqua 2000 installation to ensure the product’s normal functionality.  

  • Remove the protection paper from the foil before mounting.

  • Wind the 2 pieces of white PVC-foil slightly more than one turn around the pipe with a distance of 120 mm (use the template on the back).

  • Wind then the ALU-foil slightly more than one turn over each PVC-foil.

  • Mount the attached electrode clamps around the pipe, centred on the ALU-foil. Do not tighten the clamps too hard. Be careful not to damage the foil.

  • If there is a risk of condensation, the pipe must be insulated after the mounting in order to secure the maximum efficiency.

  • The wall unit is to be mounted max. 1 m from the pipe. Use the template and mark the holes for screws and plugs Fit the unit at the wall and connect the enclosed cable between the unit and the electrode clamp pin. Connect the net adapter to the unit and to a 230 V wall socket.

  • N.B. Cables between the Aqua unit and pipes must be separated and may not be clamped or bundled together. Otherwise the unit might not work correctly.

 

Tips: Installation in a narrow space

Faulty fitted Aqua 2000

..

  • The dissolver will now make an internal check. After approx. 60 seconds, your Aqua is in operation.

..